How to Make 3 Dog Gates

If you travel a lot with your dog, you can even leave the back of your truck while traveling, but this can be dangerous because the dog can fall off the truck when on the move without you even noticing. You can make dog gates with basic woodworking tools, hardware and plywood. Instructions:  Make the top and bottom of the box for dog. Cut with circular saw two rectangular pieces of plywood 3 feet (0.91 meters) by 4 feet (1.21 meters).

Cut two rectangles of 2 feet (0.60 meters) and 11 inches (27.9 cm) wide by 4 feet tall timber for the sides. Cutting a hole for a side dog gates that measures 1 foot (0.30 m) by 2 ft (0.60 m) wide and 10 inches (25.4 cm) in height from the bottom of each side. Cut two pieces of 3 feet (0.91 meters) by 4 feet (1.21 m) plywood, this is the front and back. Short of the front piece of a door hole measuring 1 foot (0.30 m) by 2 ft (0.60 m) wide and 10 inches (25.4 cm) high from the bottom.

12 Photos Gallery of: How to Make 3 Dog Gates

Image of: Dog Gates Design Ideas

Image of: Multifunction Dog Gates

Image of: Simple Dog Gates

Image of: Three Dog Gates

Image of: Two Dog Gates

Image of: White Dog Gates

Image of: Wood Dog Gates

Image of: Black Dog Gates

Image of: Creative Dog Gates

Image of: Dog Gates Ideas

Image of: Dog Gates With Cat

Image of: Dog Gates Wood Frame

 

Cut three rectangular pieces of plywood 1 foot (0.30 m) wide by 2 feet (0.60 meters) and 10 inches (25.4 cm) for the doors. Drill several holes at random to allow air passage, approximately 1/2 inch (1.27 cm), do it on all parts except the bottom piece. Leave an area of ​​1 inch (2.5 cm) around the edges to nail dog gates.


Share: